Expert Plumbing & HVAC Services in Mishawaka, IN

Responded to service call for air conditioning system blowing air but not cooling, with indoor temperature reading 77°F. Performed comprehensive system evaluation and diagnostic assessment of existing HVAC equipment. Inspection revealed aging system with deteriorated refrigerant line penetrations through foundation wall, showing significant corrosion on copper piping and compromised wall integrity at pipe entry points. Observed galvanized ductwork with rust staining and signs of long-term moisture exposure in basement mechanical space. System assessment confirmed loss of cooling capacity with airflow present but no temperature reduction. Provided detailed estimate for complete HVAC system replacement due to age and condition of existing equipment, including new air conditioning unit, associated refrigerant lines, and necessary infrastructure upgrades to address deteriorated components and ensure proper system performance.

Responded to no cooling complaint with system blowing air but not cooling, indoor temperature reading 77°F. Performed diagnostic evaluation on outdoor condensing unit located in side alley between buildings. System age undetermined but suspected to be over 10 years old based on equipment condition and configuration. Assessed compressor operation, refrigerant levels, electrical components, and airflow at outdoor unit to identify root cause of cooling failure.

Responded to master bathroom water leak complaint involving toilet supply line and shower. Upon inspection, accessed plumbing through wall opening to examine drain configuration and P-trap assembly. Assessed leak sources at toilet supply connection and shower plumbing system. Documented conditions via photography showing drain assembly behind wall access point and ceiling area above cabinetry where moisture intrusion was evaluated. Water remained on during inspection as leaks were not causing active damage at time of service.

Completed one-time planned maintenance on 12-year-old HVAC system. Performed standard system diagnostics and utilized refrigeration diagnostic chart to verify proper system operation across all parameters including charge levels, airflow conditions, and component function. System found operating within normal specifications with no deficiencies noted.

Successfully completed installation of Lennox ML13KC1-030 air conditioning condenser unit with CK40CT-30B coil and T4 thermostat. The outdoor condenser was positioned on a gravel bed with proper pad placement for drainage and equipment stability, with all electrical connections completed and system tested for proper operation.

Completed installation of new Lennox ML13KC1-024 air conditioning system with ADP HE31C30A130 evaporator coil integrated with existing Rheem furnace in interior mechanical closet. Installed outdoor condenser unit on exterior pad with proper clearances, connected refrigerant lines with service ports, established electrical connections, and reused existing thermostat to maintain customer's preferred control interface.

Completed installation of Lennox ML13KC1-024 air conditioning condenser unit with matching ADP HE31C30A130A0004R evaporator coil. The outdoor unit was positioned on a concrete pad adjacent to the residence, refrigerant lines were properly connected and insulated, electrical wiring was terminated at the disconnect, and the existing thermostat was reused to complete the system. All components were tested and verified operational upon completion.

# Plumbing Service - Broken/Burst Pipes - CH Responded to emergency service call for actively leaking copper pipe causing property damage in utility room. Upon arrival, confirmed water supply had been shut off by customer to prevent further damage. Conducted thorough assessment of affected area, revealing severely corroded copper piping with heavy oxidation and deterioration at joints and connections. The corrosion presented as dark greenish-black buildup with significant decomposition of pipe material, indicating long-term exposure to moisture and aging infrastructure. Documented extensive property damage including water staining on walls, floor contamination, and accumulated debris throughout the utility space. Photographed corroded pipe sections, connection points, and surrounding area to provide visual record of conditions. The affected copper line showed advanced stage corrosion requiring immediate attention to prevent recurrence of leak and potential system failure. Assessed s

Completed comprehensive tune-up service on a 24-year-old residential air conditioning system. Performed multi-point safety inspection including CO detection, gas leak check, and electrical system evaluation on outdoor condenser unit. System found operating properly with all safety checks passing; customer advised of system age and provided information regarding replacement options for future consideration.

Responded to no cooling complaint on 20-year-old residential air conditioning system with no airflow at vents. Performed diagnostic evaluation on outdoor condenser unit and identified active refrigerant leak as primary cause of system failure. Unit showed significant age-related wear and deterioration consistent with two decades of operation, requiring comprehensive assessment of repair viability versus replacement recommendation.

Completed installation of Lennox ML13KC1-024-230 air conditioning condenser unit and HE31C30A130A0004R air handler. Unit was positioned on concrete pad against exterior wall, electrical disconnects and conduit were installed per code requirements, and system was tested for proper operation.

Responded to water leak emergency in basement utility area involving dual water heater system. Upon arrival, found active leak on recirculating line between water heaters spraying water across floor. Water was draining into floor drain but main shutoff valve was inaccessible or inoperable, preventing immediate water isolation. Assessed copper piping configuration, pressure relief valves, and connection points throughout the hot water distribution system. Documented extensive water staining on concrete floor and condition of brass fittings, flexible connectors, and plumbing infrastructure. Identified source of leak at recirculation line connection point near water heater installation.

Responded to emergency call for major water leak affecting entire residence built in 1975. Upon arrival, found main water supply already shut off by homeowner. Conducted thorough inspection of plumbing system to locate source of leak. Traced leak to compromised copper piping in basement utility area near water treatment equipment. Inspected copper pipe assembly with compression fittings and elbow joints mounted along concrete block wall. Noted water damage and staining on basement walls beneath affected piping section. Evaluated condition of nearby water heater and Culligan water softening system to ensure no secondary damage occurred. Documented all findings with photographs for record. Identified failed connection point in copper piping as primary leak source. Repaired compromised section and restored water service to residence.

Completed annual Gold Level maintenance on a 9-year-old HVAC system. Performed comprehensive inspection of furnace unit model G9S1120316J, including verification of gas line connections, electrical components, and all mechanical systems. Documented filter size requirements at 16x20; customer will maintain filter replacement independently. Inspected ductwork, insulation integrity, and all accessible system components. Cleaned debris accumulation around exterior unit base. All systems operating within normal parameters upon completion of maintenance protocol.

Completed installation of Lennox ML13KC1-30 condenser unit and HE31C30A130A0004R uncased evaporator coil at residential property. System was properly charged using calibrated refrigerant recovery equipment and precision charging scale, with all refrigerant lines evacuated and tested for leaks prior to final charge. Unit was commissioned and verified operational with proper airflow and temperature differential across the coil.

Completed full HVAC replacement for apartment 329-3C, installing a new Lennox air conditioning condenser unit with uncased evaporator coil. The installation included proper electrical connections with junction boxes and disconnect switch, refrigerant line set routing between components, and mounting on concrete pad. System was tested and verified operational upon completion.

Completed scheduled air conditioning maintenance as part of HVAC membership plan within the promised 12-4pm service window. Performed comprehensive system inspection of outdoor condensing unit, including examination of refrigerant line set, associated copper piping, and condensate drainage components. All equipment photographed and documented showing proper installation and operational status of mechanical components.

Completed installation of Lennox ML13KC1-024 outdoor condensing unit and ADP uncased evaporator coil. Recovered existing R-22 refrigerant from old system using recovery equipment prior to unit removal. Mounted new Lennox condenser on existing concrete pad alongside other HVAC units servicing the multi-unit building. Installed ADP uncased coil in air handler, made refrigerant line connections, and completed electrical hookup to existing meter bank. Reused existing thermostat to maintain customer's familiar control interface. System was pressure tested, evacuated, charged to manufacturer specifications, and tested for proper operation. All components functioning as designed with appropriate temperature differential across coil.

Replaced existing water heater with new unit in basement utility area. Installation included connecting copper supply and return lines with brass fittings, integrating red-handled circulation piping, and ensuring proper PVC drainage configuration. All plumbing connections were secured and tested for leaks, with system commissioned and verified operational.

Responded to water leak in 60-year-old residential property. Upon investigation, accessed crawlspace area and inspected exposed plumbing system between floor joists. Located source of leak at corroded copper supply line connection near brass gate valve and expansion tank assembly. Repaired compromised fitting, tested system under pressure, and verified all connections were secure with no further leakage detected.